Diamond Honing Stones

Abrasive honing sticks are made in white aluminium oxide, green silicon carbide, pink aluminium oxide & blue aluminium oxide.  

We also provide radius & champher on request.

Aluminium oxide stones are available in white / brown suitable for ductile materials. Red / pink are suitable for tough alloy steels.
black aluminium oxide is suitable for low tensile materials.

Green silicon carbide stones are recommended for tough centrifugally cast iron and alloy materials.
results are faster cutting rate of material and less dressing required. These grains are more fragile and give a better finish to the component.

Black silicon carbide is the toughest and strongest grain of all. These are recommended for rough operations where more material removal is required. These grains can work even under high pressures of 28 kg/cm2. While honing.

Mixed abrasive grains are used for special purpose where particular rz and rmax values are required.
applications are for:

• Cylinder liners of tractors. 
• Connecting rods. 
• Rocker arms. 

Honing stones have a grit range of;

• 46 (very coarse) - 60 - 80 (coarse) 
• 180 - 320 (medium) 
• 500 -800 (finish) 
• 1200 - 1700 (mirror finish). 

Hardness ranges from:
g (very soft) - h - i - j (medium) - k - l - m - n - o - p (hard).
hardness of the honing stones are recommended by the manufacturer after studying the hardness of the component

Diamond & CBN honing stone :

The dimension of the honing stone depends on the

design of the honing holder/mandrel. In particular,

the height of the abrasive layer is defined by the I

possible infeed path of the holder. For the sake of

clarity, some type of honing stones are given as

below:

Standard honing stone

Honing stones having abrasive layer on steel

base. Honing stone is soldered on honing shoe /

carrier.

To write dimension: W X H X L X A

Slotted standard honing stone

Same as standard honing stone but with a slot

longitudinally for better cutting, cooling and chip

removal.

To write dimension: W X H X L X AS

Solid honing stone

This stone consists only the abrasive (No steel base)

and is also soldered on the honing shoe/carrier or

holder segment.

To write dimension: W X H X L X A

Compact honing stone

Honing stones for direct fitting into the body of the

honing holder. This type of stone is generally used

for very small bore honing.

To write dimension: W X H X L X A

Drawing of the stone required for manufacturing.

W = Width (mm) H = Height (mm)

L = Length (mm) A = Abrasive height (mm)

S = Slot width (mm)

Solutions Better Use

Various influences determine the result of the honing The characteristics of a honing stone as well as a fine

tuning of all the different parameters make it possible to achieve the required result. In addition to high quality in

manufacturing, both a short processing time and a long life of the stones can be achieved. The selection of the

Applications:

These are useful for mainly cast iron applications, super finishing cases, carbide honing, S.G. Iron and other alloy applications & non ferrous products.